![](https://atalantaowners.org/wp-content/litespeed/avatar/32f60a786f49b76043be9b5f3061c5c3.jpg?ver=1725693605)
Hi. Sorry not to reply earlier – been away sailing.
I have used the same system which is described in this post, namely armourguard and copper coat fromn reactive resins. It has now been on 2 years. Basically I am very pleased with it.
The one thing I would state about the copper coat is that it is not totally imune from fouling. However we have had a very bad year for fouling this year and all I have are barnacles underneath, between the keels, and along the keel itself. The unprotected prop and shaft was covered as well. Very little “weed” as such. So I suppose the point is that I find I have to dry out half way through each year to scrub it all off.
I am however convinced that it would be significantly WORSE if I used conventional antifouling.
As far as repairing the coating is concerned it is easy. Just abraid and degrease the affected area and recoat. I have found the armourgaurd very good – it does stick to steel and galvanising well. I have even used it on alloy and it stays on that as well.